#pragma once

#include <Arduino.h>
#include <BatteryMonitor.h>
#include <InputManager.h>

// Display SPI pins (custom pins for XteinkX4, not hardware SPI defaults)
#define EPD_SCLK 8   // SPI Clock
#define EPD_MOSI 10  // SPI MOSI (Master Out Slave In)
#define EPD_CS 21    // Chip Select
#define EPD_DC 4     // Data/Command
#define EPD_RST 5    // Reset
#define EPD_BUSY 6   // Busy

#define SPI_MISO 7  // SPI MISO, shared between SD card and display (Master In Slave Out)

#define BAT_GPIO0 0  // Battery voltage

#define UART0_RXD 20  // Used for USB connection detection

class HalGPIO {
#if CROSSPOINT_EMULATED == 0
  InputManager inputMgr;
#endif

 public:
  HalGPIO() = default;

  // Start button GPIO and setup SPI for screen and SD card
  void begin();

  // Button input methods
  void update();
  bool isPressed(uint8_t buttonIndex) const;
  bool wasPressed(uint8_t buttonIndex) const;
  bool wasAnyPressed() const;
  bool wasReleased(uint8_t buttonIndex) const;
  bool wasAnyReleased() const;
  unsigned long getHeldTime() const;

  // Setup wake up GPIO and enter deep sleep
  void startDeepSleep();

  // Get battery percentage (range 0-100)
  int getBatteryPercentage() const;

  // Check if USB is connected
  bool isUsbConnected() const;

  // Check if wakeup was caused by power button press
  bool isWakeupByPowerButton() const;

  // Button indices
  static constexpr uint8_t BTN_BACK = 0;
  static constexpr uint8_t BTN_CONFIRM = 1;
  static constexpr uint8_t BTN_LEFT = 2;
  static constexpr uint8_t BTN_RIGHT = 3;
  static constexpr uint8_t BTN_UP = 4;
  static constexpr uint8_t BTN_DOWN = 5;
  static constexpr uint8_t BTN_POWER = 6;
};